ULTRATWIN (UL)
INSTRUCTION MANUAL
44
CHAPTER 4 QUICK SETUP GUIDE
This quick set-up guide shows you how to get up and running in a few
minutes in just four easy steps after installing your UltraTWIN.
Enter Program Mode
First you need to go from run mode into program mode. Assuming the
passcode is the default 1997, then you should enter the following on the
keypad:
Choose Quick Setup
Now you need to go into the quick setup. You will see on the menu the
words ‘Quick Setup’, which is the first item on the menu system.
By default,
the UltraTWIN will always access
point 1
menu system, to
change
to
point
2
menu, press the
hot key
. Try pressing the two arrow keys to see some
more menu options, but return to Quick Setup, and press:
1 = Level or Volume (Level/Vol)
2 = Pump Control (Pump)
3 = Open Channel Flow measurement (OCM Flow)
APPLICATION
UNIT TYPE
1 = Level/Vol
When selected the UltraTWIN will be configured for
Level/Volume measurement.
2 = Pump
When selected the UltraTWIN will be configured for
pump control.
3 = Flow
When selected the UltraTWIN will be configured for OCM
measurement.
ENTER
1 9 9 7
ENTER
This takes you to the common
applications parameters, and you will see
some options appearing on the display.
