PULSAR MEASUREMENT
35
How to Access Program Mode
To enter program mode on the UltraTWIN, you simply enter the passcode,
via the keypad, followed by the ENTER key. The
default passcode
is
1997
,
so you would press the following:
Once you have entered the
program mode
the UltraTWIN
will automatically
access point 1 menu system, and the top display will show “
Program Mod
e”
in the Mode Status Line and “
Quick Setup
” in the Auxiliary Display Line, in
the case of the wall mount model, the bottom display, point 2, will be blank.
To change from one point to the other point’s menu system press the
hot key, whilst in any Main Menu heading, e.g. Quick Setup, Application etc.
and you will toggle between the two points and their relevant menu systems
Important Information
There is a time-out period of 15 minutes when in program mode. After
which time the run mode will resumed if you do not press any key.
ENTER
1 9 9 7
