ULTRATWIN (UL)
INSTRUCTION MANUAL
32
CHAPTER 3 HOW TO USE YOUR ULTRATWIN
Operating the Controls
Display
On the
wall mount
model, there are two identical displays, by default, the
top
display
will provide information on the current mode of operation, and
status of the remote communication for
point 1
(
transducer 1
), while the
bottom display
provides the same information for
point 2
(
transducer 2
).
In the case of the
fascia
model, while in the RUN mode, the single display
will provide information for
point 1
(
transducer 1)
on the
main display
line
and the
auxiliary display
provides the same information for
point 2
(
transducer 2
).
When in
Program Mode
the display of the
fascia
mount model can be
“toggled” by pressing
to change from point 1 to point 2 to access
parameters on each point.
While in the Run Mode the displays will show, the current level reading and
its units of measure, along with status messages with regards to the
Transducer, Echo reception and Fail-Safe Mode. Additionally, they can be
programmed independently to provide status messages on alarms, pumps
etc.
When in the Program mode the display is used to read information on the
Menu System, Point of Measurement, Parameter Number and parameter
details and values, which can be entered.
During Test Mode, the display is used to monitor the simulated level. A bar
graph is also provided which will provide a visual reading of the level, in
percentage of span.
