PULSAR MEASUREMENT
115
Application Parameters
Operation
P1 and P2
P*104 Measurement Units
This parameter sets the units you want to use for programming and display.
OPTION
DESCRIPTION
1 = metres
All units of measurement are
Metres
2 = cm
All units of measurement are
Centimetres
3 = mm
All units of measurement are
Millimetres
4 = feet (Default)
All units of measurement are
Feet
5 = inches
All units of measurement are
Inches
Operation
P*100 Mode of Operation
This parameter sets the mode of operation, when in run mode, and can be
set to one of the following:
OPTION
DESCRIPTION
1 = Distance (Default)
Display shows the
distance
from the transducer face
to the surface of the material measured.
2 = Level
Display shows how
full
a vessel is.
3 = Space
Display shows how
empty
a vessel is.
4 = OCM Head
Display shows how high the
head
is.
5 = OCM Flow
Display shows the instantaneous
flow
.
6 = Volume
Display shows
volume
of material in the vessel.
Important Notice
In the following parameters, * denotes the point of measurement being
used (* = parameter selectable in Point 1 and/or in Point 2).
All menu options are the same for Point 1 and Point 2. Measurement points
can be “toggled” by pressing
to change from point 1 to point 2 to
access parameters on each point.
