18
MAINTENANCE
Regular maintenance will extend the life of this pressure washer and improve its performance. The warranty does not
cover items that result from operator negligence, misuse, or abuse. To receive full value from the warranty, operator must
maintain the pressure washer as instructed in this manual, including proper storage.
Pre-operation Steps
Before starting the engine, perform the following pre-operation steps:
•
Check the level of the engine oil and the fuel tank level
•
•
Remove any debris that has collected on the pressure washer.
•
Check water inlet screen for damage. Clean inlet screen if it is clogged.
•
Check high pressure hose for damage.
•
Briefly run garden hose to flush out any debris or insects.
•
Inspect the work area for hazards.
Remove Debris
•
•
Use a damp cloth to wipe exterior surfaces. If dirt is caked on, use a soft bristle brush.
After Each Use
Follow the following procedure after each use:
•
Shut off engine and turn off water supply. Release water pressure by pointing spray gun in a safe direction and
squeezing the trigger.
•
Disconnect high pressure hose, spray gun, and nozzle. Drain water from items and use a rag to wipe down the outside
of the hose and spray gun.
•
Empty the water from the pump by pulling the recoil starter 6 times.
•
Store unit in a clean and dry area.
•
Use of a pressure washer pump conditioner is recommended, follow the instructions provided by the manufacturer of
the pump conditioner.
Maintenance Schedule
After First 5 Hours
Change Engine Oil
After Each Use
Check and Clean Water Inlet screen
Check High Pressure Hose
Check and Clean Detergent Siphoning Tube
Check Spray Gun for Leaks
Clean Debris
Check Engine Oil Level before starting
Annually (20 hr Use)
Change Engine Oil (Service more often under dirty or dusty conditions)
Annually (50 hr Use)
Check and Clean Air Filter
Annually (100 hr Use)
Service or Replace Spark Plug
WARNING!
Before inspecting or servicing this machine, make sure the engine is off and no parts are
moving. Disconnect the spark plug wire and move it away from the spark plug.
