OPERATION
15
Pre-Operation Check List
•
Read and understand this operator manual in its entirety before operating pressure washer.
•
Check oil level and add oil to the proper level if low.
•
Check connections of handle and all hoses to make sure they are secure.
•
Check all hoses for kinks and damage.
•
Check flow of water supply and make sure it is adequate (40 - 80PSI).
Starting Pressure Washer (See Fig 10-11)
•
Place pressure washer on a level surface.
•
Turn on water.
•
Purge the
system’s
pump of air by releasing the safety and squeezing the trigger of the spray gun.
•
Attach wand/lance to spray gun.
• Slide the choke lever to the “Choke”
position.
•
Holding the machine with your hand, pull the recoil handle (starter cord) slowly until resistance is felt, then pull rapidly.
Squeeze the Gun trigger and release the pressure after every failed attempt to start the pressure washer (This will
reduce the back pressure).
•
Let engine run for several seconds and then gradually slide the choke lever to the RUN position as the engine warms
up until the choke is fully slid to the RUN position.
FIG 10
FIG 11
CAUTION!
Do not run pressure washer with a damaged hose. Do not run pressure washer without
result. FAILURE TO FOLLOW THESE INSTRUCTIONS WILL VOID PRODUCT WARRANTY.
WARNING!
from dissipating.
•
Carbon monoxide gas is a poisonous, odorless gas that can cause headache, confusion, fatigue, nausea, fainting,
sickness, seizures, or death. If you start to experience any of these symptoms,
IMMEDIATELY
get fresh air and seek
medical attention.
•
•
•
When working in areas where vapors could be inhaled, use a respirator mask according to all of its instructions.
CHOCK
RUN
start
CHOCK
RUN
