P-TRPV1
v1.1
P-TRPV1 -set of passive HD video and power transmitters
Edition: 2 from 05.06.2019
Supercedes the edition: 1 from 01.06.2017
EN
1. Technical description.
The P-TRPV1 is a set of passive devices used for HD video and power transmission using a twisted pair cable.
The video signal is transmitted using one twisted pair, while the power is supplied using two twisted pair cables. The set of
devices matches the impedanc
e of the coaxial cable (75Ω) to the impedance of the symmetrical cable (100Ω).
In order to achieve the best transmission quality and interference immunity, use UTP cable cat. 5 (or higher). Make sure the
cable is properly prepared when making the connection. The RJ45 terminal crimp diagram is shown in Figure 1 presented
below:
Caution! An improperly made cable may cause damage to the camera.
The P-TRPV1 modules are terminated with two types of connectors:
a) the BNC plug (HD-CVI / HD-TVI / AHD video transmission),
b) JACK 2,1 / 5,5 power socket (camera power supply).
The module is equipped with LED (located indoor the RJ45 connector). Red LED indicating the supply voltage.
Fig.1. The RJ45-RJ45 (T-568B) wiring diagram.
The use of the P-TRPV1 set significantly reduces the CCTV system installation time. To install the cameras, simply crimp the
RJ45 connectors (making a straight RJ45-RJ45 cable) and connect the appropriate video and power terminals.
EN
