Pulsar MICROFLOW, Instruction Manual, Page: 58 / 65

Page
52
P22 Signal Strength
This is a ‘read only’ parameter and gives you the current signal strength in a
percentage, from 1 to 100.
P23 Stability
This is a ‘read only’ parameter and gives you the current stability in a percentage,
from 1 to 100.
Configuration parameters
RS485 Communication and Modbus
Use these parameters to setup the MicroFlow device to the appropriate Pulsar
controller.
Device Information Parameters
These parameters are read-only.
Name Parameter
No.
Description
Serial Number
240
&
241
Registers 240 & 241 form a 32-bit number.
Register 240 = Most significant 16-bit.
Register 241 = Least significant 16-bit.
Firmware ID 261
A number associated with the version of
firmware that is currently programmed onto the
sensor.
Hardware ID 262
A number associated with the version of
hardware that is currently used with the sensor.
Name
Parameter
No.
Options Default Description
MicroFlow Sensor
Address
52 1 – 127 126
Unique Modbus
device ID.
Modbus
Terminations
57
0 = Off
1 = On
1
Select 1 = On, if
termination is
required.