Pulsar Flow Monitor, Instruction Manual

Page: 37 / 61

Page 31
Device Comms
P141 Protocol
This parameter determines the communication protocol that the processor
uses to initialise the FlowPulse sensor.
Option Description
0 = Modbus RTU (Default) Modbus RTU with hexadecimal data
1 = Modbus ASCII Modbus ASCII with ASCII data
P142 Device Address
This parameter determines the address of the FlowPulse sensor that the
processor is connected to.
Default = 126
P143 Device Baud
This parameter determines the baud rate that the processor uses to
communicate with the FlowPulse sensor.
Default = 19200 baud
P144 Parity
This parameter determines the communication parity that the processor uses
to communicate with the FlowPulse sensor.
Option Description
0 = None (Default) No parity
1 = Odd Odd parity
2 = Even Even parity
P145 Stop Bit
This parameter determines the communication stop bit that the processor
uses to communicate with FlowPulse sensor.
Option Description
1 = One Stop (Default) One stop bit
2 = Two Stop Two stop bits