Pulsar dBi-M, Instruction Manual

Page: 18 / 71

dBi-M INSTRUCTION MANUAL
18
Preparation for Operation
Before switching on, check the following:
✓
The dBi Series Intelligent Transducer is mounted correctly.
✓
The power supply is correctly installed.
Maintenance
There are no user serviceable parts inside your dBi-M Series Intelligent
Transducer, if you experience any problems with the unit, then please
contact Pulsar Measurement for advice.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on
the enclosure.
Parameter Defaults
Once you are satisfied with the installation, and the dBi-M Series Intelligent
Transducer is reading what you would expect in terms of distance from the
face of the transducer to the material. Then you can proceed with any
programming, required for the intended application. It is sensible to
program all required parameters at the same time as soon as programming
is complete the system will then be setup ready for use.
Factory Defaults
When first installing the dBi-M Series Intelligent Transducer, or
subsequently moving or using the unit on a new application, before
proceeding to program the unit for its intended application it is
recommended that you ensure that all parameters are at their default
values by completing a
Factory Default P930, as described in the relevant
unit type parameter guide . This can be done by using the free dBi-M PC
software.