Pulsar dBi 10, Instruction Manual, Page: 35 / 55

PULSAR MEASUREMENT
35
CHAPTER 5 PARAMETER LISTING AND DESCRIPTION
Application
Operation
P100 Mode of Operation
This parameter sets the mode of operation, when in run mode, and can be
set to one of the following:
OPTION
DECRIPTIONS
1= Distance Display shows the distance from the transducer
face to the surface.
2= Level (Default) Display shows how full the vessel is.
3= Space Display shows how empty a vessel is.
4= Volume Display shows volume of material in the vessel
P102 Material
This parameter should be set to the type of material being monitored.
OPTION
DECRIPTIONS
1 = Liquid (Default) Use for liquids and flat solid materials
2 = Solid Solid material that is heaped or at an angle
3 = Closed Tank Use for closed tanks or domed roofs.
Distances
P104 Measurement Units
This parameter sets the units you want to use for programming and display
OPTION
DECRIPTIONS
1 = metres All units of measure are METRES
2 = cm All units of measure are CENTIMETRES
3 = mm All units of measure are MILLIMETRES
4 = feet All units of measure are FEET
5 = inches All units of measure are INCHES