DBI (HART) INSTRUCTION MANUAL
26
Any transducer drawing 9mA or above will have a cycle time of 1 second.
Accessing Parameters
To view or change parameters values one of the following methods must be
used:
Hart Commands
If familiar with the use of HART protocol and the dBi Series Intelligent
Transducer is connected to a HART modem, then it can be programmed
following normal HART procedures.
Commands implemented by the dBi Series Intelligent Transducer are as
follows:
Universal
0, 1, 2, 3, 6, 7, 8, 9, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 38 and 48.
Common practice
33, 34, 35, 40, 41, 42, 45, 46, 47, 83, 89, 90, 111, 112 and 122.
dBi Hart PC Lite
Your dBi Series Intelligent Transducer comes complete with the dBi HART PC
Lite
software contained on CD, which, when used with a HART Modem, see
for full details on how to connect the modem, can be
used to carry out the programming of the dBi Series Intelligent Transducer.
Insert the CD into the CD drive or download the software from the Pulsar
website (onto the PC intended to be used to carry out the programming of
the dBi Series Intelligent Transducer and install the software, following the
on-screen instructions.
Once the software is installed connect the computer via a convenient USB
port to the HART Modem. Double click the ‘dBi HART PC Lite’ icon, installed
on your desktop and the programme will open and you will see the
following screen:
Summary of Contents for dBi 10
Page 2: ...2...
Page 11: ...PULSAR MEASUREMENT 11 EU Declaration of Conformity...
Page 23: ...PULSAR MEASUREMENT 23...
Page 24: ...DBI HART INSTRUCTION MANUAL 24...