3
ENGLISH
The Core external power adapter is designed to power the thermal imaging devices (sights, attachments) of the
CORE series from external power sources such as the Power bank and EPS3I (SKU:
rechargeable batteries.
Specifications
SKU #
79163
Power bank input voltage (USB plug), V
5
EPS3I / EPS5 input voltage (2.1x5.5 mm plug), V
12
Operating temperature, °C
0 ° С ... 45 ° С / -20 ° С ... + 60 ° С
Dimensions, mm
64.1x44.1x35.4
Weight, kg
0.028
Improvements may be made to the design and specification of this product to enhance its user features.
The current version of the Operating Manual can be found on the website www.pulsar-vision.com
Package contents
•
Core External Power Adapter
•
USB cable
•
Operating manual
•
Warranty sheet
How to connect
•
Open and remove the cover of the Core battery box
(1)
.
•
Install the external power adapter into the battery box of the device (see
Fig.).
•
Make sure the latches
(C)
of the adapter have closed with a snap on both
sides.
•
Fix the cover
(1)
on the adapter.
•
Connect your Power bank to a USB port (5 V) or an EPS3I / EPS5 power
supply unit to an external power connector (12 V). Switch on the device.
•
To remove the external power adapter, press the latches on both sides.
Remove the adapter.
Note:
When using your own power supply in the power plug connected to the
device, the central contact must be “
+
”.
Possible marking on the plug or power source:
.
Attention!
When operating from an external power source, the battery
discharge indication (
icon within the device) does not show the current
charge level.
5V
12V
C
1
C
Push
Push
Precautions
•
Do not leave a working device with a connected external power source unattended.
•
Do not use the adapter if its construction has been altered or damaged.
•
Do not expose the adapter to high temperatures and naked flame.
•
Do not immerse the adapter.
•
Do not dismantle or deform the adapter.
•
Do not subject the adapter to strikes and falls.
Troubleshooting
The table shows a list of potential problems that may occur when using the adapter. Carry out the
recommended checks and troubleshooting steps following the order listed within the table. If there are defects
that are not listed below, or it is impossible to repair the defect yourself, the device should be returned to be
repaired.
MALFUNCTION
POSSIBLE CAUSE
CORRECTIVE ACTION
The Power Bank external power
source does not work when being
connected to the adapter.
The USB port contacts are dirty/
oxidized.
Clean the contacts of the USB port
gently.
The mechanical integrity of the USB
port contacts is damaged.
The device should be returned to be
repaired.
The EPS3I or EPS5 external power
source does not work when being
connected to the adapter.
The DC connector contacts are dirty/
oxidized.
Clean the contacts of the DC
connector gently.
The DC connector central contact is
compressed.
Unclip the DC connector pin with a
screwdriver gently.
The mechanical integrity of the
contacts of the DC connector is
broken.
The device should be returned to be
repaired.
There is no contact between the
adapter and the device.
The device or adapter contacts are
dirty/ oxidized; or the mechanical
integrity of contacts is damaged.
Clean the contacts gently.
