Page 5 of 52
1.
Introduction
THIS DOCUMENT CONTAINS INFORMATION TO BE USED BY QUALIFIED PERSONNEL ONLY
1.1 Receiving Inspection
All materials relative to supply are delivered to the shipper in perfect condition after thorough final
testing and packaging. Inspect goods immediately upon receipt and check:
o
The goods received correspond to the order made
o
The packaging has not undergone damage due to transport or has not been tampered with
o
The actual condition of goods
If anomalies or damage are found immediately issue a complaint with the courier and inform
Pulsafeeder aftermarket service at
or call Pulsafeeder at 585-292-8000.
1.2 General Information
The purpose of these instructions is to refer information deemed necessary for understanding as
much as possible about and facilitating the installation, commissioning, use and maintenance of
hydraulic diaphragm metering pumps.
1.3 Personnel Responsible for Pump Operation
Anyone operating the pump should have read and understood the instructions set forth within this
manual. The employer must instruct all staff on the risks of accidents and on devices and clothing
to be used for individual safety.
1.4 Testing
Each Pulsafeeder metering pump is a reliable quality product, subject to careful final inspection to
ensure their proper functioning and found compliance with the specified performance. The final test
results, if specifically requested by contract, are registered and made available to the customer.
Pulsafeeder offers many different tests available with your PulsaPro pump.
1.5 Warranty
PulsaPro metering pumps are guaranteed for a period of eighteen (18) months from the date of
shipment. Drive assemblies (gearing, shafts, eccentric, and related components within gearbox)
are guaranteed for a period of sixty (60) months from the date of shipment. The guarantee covers
replacement, free of charge, of any component found to be defective in material or processing by
the Aftermarket Service Group at Pulsafeeder, Inc.
The Warranty is NOT valid in the following cases:
o
Components subject to normal wear (gaskets, seals, O-rings)
o
Installation and/or use do not meet the technical conditions of sale and instruction
o
If the pump has been tampered with or disassembled
o
Motor (drive) is covered by the motor manufacturer
Always avoid disassembly or attempt repairs of products still under warranty, as doing so will void
the warranty. Activate the warranty on your PulsaPro pump by registering the serial number at
http://www.pulsa.com/warranty-registration
. Any questions please contact Pulsafeeder at 585-292-
8000.
