Quick Operation Guide
V1.0B1
1.
Inserting Batteries
Fig.1
Open the battery cover
Fig.2
Insert two AAA batteries in the right polarity, and close the battery
cover.
Note: Do not insert batteries with their polarities reversed!
2.
Power on and measurement
1. Palm Measurement
Fig.3
Press the
/
button to power on the monitor.
Fig.4
Press the
“START” button to enter preparing stage.
Fig.5
Fig.6
During the preparing stage, hold the electrode with your hands
as shown the above two pictures.
Note: Please make your hands contact electrode of monitor
fully for a high quality ECG results.
Fig.7
After finishing preparing stage, the ECG measurement begins
and will takes 30 seconds for a measurement under Easy
mode. Refer to fig.7 for measurement interface.
Fig.8
Under Easy mode, the monitor will analyse the measurement
result after finishing measurement, refer to Fig.8. And save
the measurement results in 8 seconds.
2. Chest Measurement
If palm measurement is not ideal, please adopt chest
measurement. Hold the unit with right hand and place the
electrode against left chest on bare skin about 5cm bellow left
nipple
.
Fig.9
3. Cable Measurement
For higher quality ECG measurement, it is recommended to
apply cable cable measurement.
The correct connection steps are as follows:
1. Place the electrode slices on your body as indicated
as fig. 10.
2. And then connect the cable and the unit effectively
through the lead port.
The position for placing the cable electrode is shown in
Picture.
Fig.10
