HoopKlipperz
HoopKlipperz
Pat. Pend.
Activity Guide
Using HoopKlipperz
The “C”-Clips are designed to fit very tightly around hoops and 3/4”
wands so that they have to hold snuggly. To insert hoops (and remove
them) press them into the C-Clip at an angle (image “A”)...this will
make it easier to insert and remove hoops. The grip may occasionally be
so strong between hoop & Clip that the arm ball-joint pops out (B) when
separating hoop & Clip. If this occurs they can be reconnected by firmly
pressing the two parts against the ground. Should the connection be-
tween hoop & Clip be slightly loose due to an unusually “thin” hoop,
simply wrap the hoop once or twice with 1” dia. floor tape,
and insert the Clip over the area covered by the tape. This
will create extra gripping.
Rotating The Clip For More
Configurations…
The Clip on the shorter length of the elbow bar turns 360
degrees so that a connected hoop/wand can be turned in
what ever direction or angle you wish. Note that this Clip
doesn’t rotate easily...this is by design, so that when
you set it to the position desired it will hold in place.
Rotate the Hoop
to any position!
Insert/separate hoops
at an angle!
Hoop positioned
to the side...
Hoops
Aligned
together
Dozens Of Set-Up Positions
For Targets & Obstacles!
The variety of
HoopKlipperz
set-up positions is almost
as wide as your imagination. Set hoops and wands
vertically or horizontally to create everything from
frisbee targets to multi-height hurdles...even create a
complete obstacle course, all of which sets up, breaks
down, and stores compactly.
HoopKlipperz
are also as stable outdoors as indoors;
even in the wind. Additional uses include field
markers & boundaries, soccer-skill targets, move-
through tunnels, foot-speed/agility obstacles, “safety
zones” in tag games, and as pieces for
creative building.
A
B
4-Target Bean Bag Toss
For 4 Players At Once!
