27
Rev 1.3 10/20
Network Connection
1.
Operating Environment
Operating System: Windows 2000 / 2003 / XP / Vista / 7 / 8.1 / 10, Mac Catalina and later
Network Protocol: TCP/IP
Client PC: P4 / 128M RAM / 40GHD / support for scaled graphics card, support for DirectX8.0 or more advanced
version.
2.
Equipment Installation
1. Connect the camera to your network via a CAT5 or CAT cable directly to your network switch.
2. Turn on the camera.
3. Once powered on, the orange network light will illuminate and the green light will start flashing.
3.
Network Connection
Connect the camera & PC to the LAN as shown below.
Picture 1.1 Direct connections via “cross-over” network cable
Picture 1.2 Connections to LAN via patch cable to LAN wall jack or LAN switch
Setting up a Network Video Stream
1.
The first thing you are going to want to do to get your camera up and streaming on your network is to connect
your camera to power, an active network port on your network, and finally, power on the camera.
Summary of Contents for EPTZ NDI HX ZCAM G2
Page 2: ...i Rev 1 3 10 20...
