00031120.DOC, Version 1.0
25/25
8.1 Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1:
Unscrew the fuseholder with a fitting screwdriver from the housing (anti-clockwise).
Step 2:
Remove the old fuse from the fuseholder.
Step 3:
Install the new fuse in the fuseholder.
Step 4:
Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
9. TECHNICAL SPECIFICATIONS
Power supply:
230 V AC, 50 Hz ~
Frequency response:
20 Hz - 20 kHz
Signal-to-Noise ratio:
>88 dB
Total Harmonic Distortion:
0.1 %
Damping factor:
450
Voltage gain:
34.3 dB
Slew rate:
30 V/
Z
sec.
Crosstalk:
72 dB
Input sensitivity:
0.77/1/1.4 V
Input impedance:
10/20 kOhms (bal./unbal.)
Input connectors:
2 x XLR mounting socket
Output connectors:
2 x Speaker (stereo), 1 x binding post (bridge)
Protection:
Overheat, overload, short-circuit, DC, softstart
Cooling:
2 fans
Controls:
Power switch, input attenuators, Mode switch - Stereo/Parallel/Bridged, Ground
Lift
Indicators:
Signal, Clip, Protect, Power
Construction:
Steel chassis, aluminium front panel
Dimensions:
456 x 482 x 88 mm
19"-dimensions with 2 u
HP-1400
HP-2400
HP-3200
Power consumption:
2835 W
4860 W
6480 W
Power output (RMS):
Stereo 4 Ohms
2 x 700 W
2 x 1200 W
2 x 1600 W
Stereo 8 Ohms
2 x 400 W
2 x 690 W
2 x 920 W
8 Ohms bridged
1 x 1400 W
1 x 2400 W
1 x 3200 W
Weight:
17 kg
22 kg
24 kg
Fuse:
T 10 A, 250 V
T 12 A, 250 V
T 15 A, 250 V
Please note: Every information is subject to change without prior notice. 09.01.2008 ©
