3
1
2
CC
3
CC
4
CC
2
Quick Start Guide
1
Connect power source
Conne
e
(PN 91
9 4
**
*
***
4
2
Power
Button
Power
LED
Battery
LED
Fault
LED
Feed
Button
Paper Door
Release
Battery
Release
Depress door,
release lever
Printers may also be ordered from Psion pre-configured, if desired.
Use this guide to configure your new PRINTABOUT printer prior to use.
PRINTABOUT printers may be operated directly from an external power
source without a battery present. If no battery is to be used, battery
charging may be skipped. (A battery compartment cover is available
from Psion).
Maximum battery capacity is reached only after completing three
complete charge and discharge cycles. Psion recommends
completing three cycles before deploying your printer for best results.
With media rolls of less than 4” width we recommend addition of a
second paper guide. See reverse for details.
Tear Direction
© Copyright 2011 by Psion Inc.
2100 Meadowvale Boulevard, Mississauga, Ontario, Canada L5N 7J9 http://www.psion.com
Psion, the Psion logo, and the names of other products and services provided by Psion are trademarks of Psion Inc.
All trademarks used herein are the property of their respective owners.
Power Input Port
I/O Port Cover
Carrying Strap
Paper
Door
Paper
Exit
(PN 33012 AC Adaptor, or
PN 33017 In-Vehicle Adaptor).
Charge the Battery
Load Paper
Perform Printer Test
Install battery*
(loosen carrying
strap if necessary).
Battery LED should illuminate.
Charge until LED goes out**
(approx. 2-3 hours).
Drop paper in ***
Close door
Paper guide
Rear Detail Other Side
Top
Front
1
Start with power off.
Hold Feed Button , then press Power Button.
Printer will prompt you to press if you want to enter Setup Menu.
(more on Setup Menu on reverse)
CC
3
Continue to hold Feed Button until printer beeps twice.
LED will flash, Test Page will print.
PN 8000249 Rev A
December 2, 2011