Psion Teklogix WORKABOUT PRO Hand-Held Computer User Manual
111
Chapter 6: Connecting To A LAN With 802.11b
Connecting To A LAN Using An 802.11b Radio
•
Fit the CF stopper over the card, and use the four screws provided to secure
the stopper in place.
Figure 6.4 CF Stopper Installed
•
Install the battery, and replace the backplate.
•
Slide the SW1401 switch to the right to turn power back on.
•
Replace the end-cap, and tighten the four Philips screws to secure
the end-cap.
Important:
The WORKABOUT PRO does not support hot swapping cards.
All power sources must be switched off before inserting a card
in the unit.
6.2 Connecting To A LAN Using An 802.11b Radio
Once the 802.11b radio is installed in the WORKABOUT PRO, you’ll need to take
a few steps to configure the radio.
6.2.1 Configuring An IEEE 802.11b Radio
While most common 802.11b settings are configured as defaults, there are some
fields that must be completed, including the SSID of your access point and the
security methods implemented in the network (including access keys).
CF Card Stopper
Installed
