Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 300 / 348

Appendix D:Radio Parameters
Channel
D-16
Teklogix 7035, 8255 & 8260 Terminals User Manual
Manual Table
This parameter can be used to set the channel search order the terminal will use if
communication quality drops and channel switching is required. If this parameter is
left at the default setting of “N”, the terminal uses a standard algorithm to decide
which channel it should switch to in the event of poor channel quality.
If “Manual Table” is set to “Y”, the terminal uses the channel switching lists
specified in the Manual Table. Each channel list consists of up to 8 channels,
with all channels enabled before they are entered into the “Manual Table”. If
communication quality falls below 46%, only the channels entered in the
“Manual Table” are considered for channel switching. The channel search is
carried out in the order in which the channels were entered in the table.
To move the cursor to the right to the next channel in a channel list:
• Press the <TAB> key.
To move the cursor to the left in a channel list:
• Press <SHIFT><TAB>.
Warning: It is not recommended that the “Manual table” parameter be used
without a clear understanding of how to order the channel
sequences for optimum performance.
CH 1 list 0 0 0 0 0 0 0 0
•
•
•
CH 20 list
0 0 0 0 0 0 0 0
Manual Table