Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 216 / 348

Chapter 7:Setting Parameters
SNMP (Simple Network Management Protocol)
190
Teklogix 7035, 8255 & 8260 Terminals User Manual
Group Name
The name assigned here allows MapRF users to group devices by a common name.
This name is defined in the TEKLOGIX-GENERIC-MIB (refer to the introductory
paragraph under the heading “SNMP (Simple Network Management Protocol)” on
page 189 for details about MIBs). The “Group Name” is also displayed on the
terminal statistics screen.
Contact
This field identifies the contact person for this managed node along with
information about how to get in touch with this person.
Name
The value assigned here is the name assigned by the network administrator for this
managed node. Normally, this is the node's domain name.
Location
This parameter is used to identify the physical location of this node (e.g., Warehouse
A: Pillar 32B).
SNMP Enable
When ‘SNMP Enable” is set to “Y”, the default value, SNMP functions are enabled.
If SNMP is not used, set this parameter to “N” to disable this feature.
Auth Trap
A trap is a report sent to SNMP managers when authorization failures occur. The
value assigned to this parameter is defined in MIB-II. Setting the “Auth Trap”
parameter to “Y” allows authorization traps to be sent when a failure is detected
(e.g., an SNMP message received with a bad community name).
Communities
#1 » see text
#2 »
#3 »
#4 »
#5 »
#6 »
Communities
Range