Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 144 / 348

Chapter 7:Setting Parameters
Terminal Parameters
118
Teklogix 7035, 8255 & 8260 Terminals User Manual
7.4 Terminal Parameters
Warning: Parameters should not be altered without a clear understanding of
how they operate. Parameters that are incorrectly set can increase
response time or cause communication difficulties. Generally,
parameters are configured for each site during installation.
The “Parameters” menus can only be accessed by individuals with the proper
security password. Security is divided into two levels: Supervisory and Psion
Teklogix Personnel passwords. Refer to “Security” on page 194 for details about
changing the default supervisory level password. Refer to “Allow Teklogix” on
page 194 for details about the Psion Teklogix support level password.
Important: Only individuals with a supervisory level or Psion Teklogix
support level password can access and change these parameters.
7.4.1 Displaying The Parameters Menu
The “Parameters” application is launched from the start up “Display Menu”. If your
terminal is currently in the Tekterm application:
• Press <ALT>, and type the letter x.
The “Display Menu” appears on your screen.
To display the “Parameters” menu from the startup “Display” menu:
• Type the letter a.
• Type your supervisory level password in the ‘Password’ window, and press
<ENTER>. This is 123456 by default. (Refer to “Security” on page 194 for
details on changing the default password.)
A Parameters
B Emulations
C DOS Prompt
01 Display Menu