Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 137 / 348

Teklogix 7035, 8255 & 8260 Terminals User Manual
111
Chapter 7:Setting Parameters
Using The Parameter Manager
Important: If you are uncertain how to operate your terminal keyboard, refer
to Chapter 3: Keyboards – Operating Instructions beginning on
page 45.
7.1 Using The Parameter Manager
Warning: Parameters should not be altered without a clear understanding of
how they operate. Parameters that are incorrectly set can increase
response time or cause communication difficulties. Generally,
parameters are configured for each site during installation.
The Parameter Manager provides access to the parameter menus. The values
assigned to the parameters can be viewed and adjusted to optimize communication
at the site in which a terminal is operating.
Note: Parameters can also be remotely modified using SNMP.
7.2 Exiting Tekterm And Accessing The Display Menu
Normally, the Tekterm application is automatically launched when the terminal is
turned on.
Exiting Tekterm
To launch the Parameters menu, you first need to exit the Tekterm application:
• Press <ALT>, and type the letter x.
The start up “Display Menu” appears on the terminal screen. From this menu, you
can launch the “Parameters” menu, relaunch the Tekterm application, or go to the
DOS prompt.
A Parameters
B Emulations
C DOS Prompt
01 Display Menu