D-34
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Appendix D: Teklogix Imagers Applet
Bar Code Symbologies – Descriptions
Discrete 2 of 5
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths –
1 to 48.
D.5.17 Discrete 2 of 5
Enabled
Set this parameter to
on
to enable “Discrete 2 of 5”.
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths –
1 to 48.
D.5.18 Telepen
Enabled
Set this parameter to
on
to enable “Telepen”.
Enable AIM Output
If you set
Enable AIM
Output to
on
, the imager reads symbols with start/stop pattern 1 and
decodes them as standard full ASCII (start/stop pattern 1). If you set this parameter to
off
,
the imager reads symbols with start/stop pattern 1 and decodes them as compressed numeric
with optional full ASCII (start/stop pattern 2).
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths –
1 to 60.
D.5.19 GS1 DataBar
GS1 DataBar
Set this parameter to
on
to enable the imager to read “GS1 Databar” symbols.
