Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
D-31
Appendix D: Teklogix Imagers Applet
Bar Code Symbologies – Descriptions
Code 93
D.5.10 Code 93
Enabled
Set this parameter to
on
to enable “Code 93”.
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths –
0 to 80.
D.5.11 Codabar
Enabled
Set this parameter to
on
to enable “Codabar”.
Start/Stop Strip
Codabar can use the following sets of characters as start and stop characters:
a, b, c, d
A, B, C, D
a, b, c, d, /, t, n, *, e
DC1, DC2, DC3, DC4
Setting this parameter to
on
strips the start and stop characters from this bar code.
Check Char
When this parameter is enabled, before data is output, the “Codabar” symbol integrity is ver-
ified based on a parity character that must be present in the code. If the parity character is not
part of the code, the code is not output. Keep in mind the parity character may not be part of
your output setup; in this case, this parameter should be turned
off
.
Check Char Strip
If you enable this parameter, a check character is stripped from the decoded bar code data.
Concatenation
“Codabar” supports symbol concatenation. When
Concatenation
is set to
on
, Codabar uses a
‘D’ stop character to indicate that data from that symbol should be concatenated with data
from the adjacent symbol with a ‘D’ start character.
