Chapter 2: Basic Operation
Preparing Omnii for Operation
14
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
2.2
Preparing Omnii for Operation
2.2.1
The Battery
Omnii is powered by a Lithium-ion Smart Battery pack, 5000 mAh—Model No. ST3000.
Battery packs shipped from the factory are charged to approximately 40% and must be fully
charged prior to use. Batteries can be charged using a variety of chargers and docking sta-
tions. For detailed information, see “Battery Details” on page 35.
2.2.2
Replacing the Battery Pack
Figure 2.6 Omnii Battery
Important: Before charging the battery, it is critical that you review the battery safety
guidelines in the Omnii Hand-Held Computer Regulatory & Warranty
Guide (PN 8000191).
Important: Always switch the unit off before changing the battery (see “Switching
Omnii On and Off” on page 15). If you do not turn the hand-held off before
removing the battery, it may be necessary to reboot the unit. Any active ses-
sions may be lost.
2 - Battery Compartment
Contacts
Battery Top
Battery Bottom
1 - Release Latch
3 - Guide Tabs
4 - Latch Tabs
3
3
3
1
1 2
4
4
Note: If you are using a docking station or an external power supply, you can insert an
uncharged battery and use the device while the battery charges.
