C-42
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Appendix C: Bar Code Settings
Imager
Imager Options
C.4
Imager
•
Tap on the
Scanner
drop-down menu, and choose
Imager
.
C.4.1
Imager Options
TekImager Enabled
Setting this option to
on
enables the imager installed in your hand-held.
Continuous Scan Mode
Setting this parameter to
on
keeps image capture active and continuously decoding as long
as the scanner button is pressed and held down.
Center Barcode Only
When more than one bar code is visible in a single snap shot, this parameter allows you to
specify that only the centre image within the imager framing marker be read. When this pa-
rameter is set to
on
, the target dot is pointed at the centre image and only that image is
returned.
Max Number Barcodes
Specifies the maximum number of bar codes the imager attempts to decode in an image. A
maximum of 6 bar codes can be decoded at one time.
Note: This parameter must be disabled when reading Composite bar codes.
