Chapter 6: Peripheral Devices & Accessories
Indicators
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
183
6.7.2
Indicators
The front-mounted LED on the desktop docking station indicates the spare battery charge
status. The LED on Omnii is active even when the hand-held is inserted in a docking station
(and in suspend mode) so that the charge status of the battery can be detected easily.
Table 6.6 Docking Station Battery Charge LED Behaviour
6.7.3
Operation
6.7.3.1 Charging the Omnii Battery
The desktop docking station supplies DC power to enable the Omnii internal fast charger.
When installed in the dock, the Omnii battery charge LED will illuminate to indicate the
unit has external power and can charge the internal battery. Omnii charge indication follows
the same convention as the charger's spare battery indicator (Figure 6.8).
6.7.3.2 Charging the Spare Battery
•
Install the battery in the battery charge well (rear slot of the desktop docking station).
Place the battery contacts down to mate with the connector, and pivot the battery into
place in the battery charge well.
•
The desktop docking station spare battery LED lights up immediately. During charge
the LED will be flashing green.
Charge LED Behaviour
Function
OFF
No battery detected.
Solid Green
Battery charging complete.
Flashing Green
Charge in progress.
Flashing Yellow
Battery is not charging due to out-of-temperature conditions.
Solid Red
Unable to read battery or non Psion Teklogix battery.
Note: Battery charging continues whether Omnii is switched on or off.
Important: Do not store spare batteries in a charger for more than 72 hours. Doing so
may damage the battery or reduce its charge capacity.
