Chapter 6: Peripheral Devices & Accessories
Carrying and Protective Accessories
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
173
6.4
Carrying and Protective Accessories
There are a variety of carrying and protective accessories to help the operator work safely
and comfortably with Omnii.
Attaching Carrying Accessories
If your Omnii is not fitted with a hand strap, you can install it using the carrying accessory
kit supplied. You’ll need:
• A Phillips head screwdriver.
Table 6.4 Accessories Model Numbers
6.4.1
Attaching the Hand Strap - Model No. ST6025
• Attach the strap to the two threaded inserts located at the back of the hand-held near
the top of the unit (see Figure 6.2), using the two Phillips head screws provided with
this accessory.
Note: Omnii Hand-Held Computer is a body worn device, and to maintain compliance with
the FCC RF exposure guidelines, use a Psion Teklogix approved carrying case. Use
of non-approved accessories may violate FCC RF exposure guidelines.
Important: Do not use adhesives such as Loctite to secure screws on carrying
accessories. These chemicals may damage the plastic casing.
Accessory
Model Number
Wrist Strap
ST6040
Hand Strap
ST6025
Shoulder Strap
ST6030
Soft Shell Holster
ST6050
Hard Shell Holster
ST6055
Forklift Holster
ST6051
Carrying Case
ST6090
Pouch
ST6091
Screen Protector
ST6112
