PSG CADDY MAX CADDY WOOD ADD-ON PF01102, Installation And Operating Instructions Manual

Page: 4 / 54

4
IMPORTANT NOTE:
THE INSTALLATION OF THIS CENTRAL HEATING SYSTEM MUST BE PERFORMED BY A
QUALIFIED TECHNICIAN. PSG RESERVES ITSELF THE RIGHT TO VOID ITS WARRANTY
OR DENY TECHNICAL ADVICE IF THE ADD-ON HAS NOT BEEN SOLD OR INSTALLED BY A
PROFESSIONAL.
REGISTER YOU WARRANTY ONLINE
To receive full warranty coverage, you will need to show evidence of the date
you purchased your Add-on. Keep your sales invoice. We also recommend
that you register your warranty online at
http://www.caddyfurnaces.com/en/warranty/warranty-registration
Registering your warranty online will help us track rapidly the information we
need on your add-on.
1. INTRODUCTION
Take note that this add-on operates like an EPA wood burning stove. This applies to the lighting, the ember bed, and
the minimum combustion air intake which was determined based on the use of good seasoned cordwood.
The Max Caddy add-on was tested and approved according to the CSA B415.1-10 Standard.
To optimize the efficiency of your add-on, here is some advice that you should follow when installing or operating your
Max Caddy add-on.
•
Respect the local codes (when in doubt, consult your local dealer);
•
Make sure your add-on is installed according to the instructions on the certification label;
•
All controls and adjustments must be performed by a qualified technician. The blower speed of the existing
furnace must conform to the recommendations of local codes and should respect the static pressure ranges in
the warm air plenum of the add-on.
We recommend that our wood burning hearth products be installed and serviced by professionals who are certified in
Canada by WETT (Wood Energy Technical Training) or in Quebec by APC (Association des Professionnels du
Chauffage).
This add-on has been developed and built for residential heat source. Commercial and industrial use is prohibited and
will void the warranty.