User’s Guide
11
Auto-Learn
Auto-Learn is the simplest method of customizing the Mini Power-
Wedge. With Auto-Learn, you “teach” the decoder to accept the types
of bar codes you use.
The current settings for the Mini PowerWedge remain unchanged
unless they are explicitly set during Auto-Learn programming. For
example, enabling Code 11 does not affect other symbologies. To dis-
able all symbologies except the ones you want to use, program the
decoder to use Predefined Default 0 (see page 10) before starting
Auto-Learn.
To program the Mini PowerWedge using Auto-Learn . . .
1.
Scan the
START
bar code below. (The bar code also appears on
the last page of this booklet.)
2.
Scan a sample of each of your
bar code labels. Be sure the
decoder beeps after each read. It is important that you scan
each type of label (e.g., Code 39, UPC) as well as the smallest
and largest bar codes (e.g., 6 characters and 10 characters)
that you want the decoder to read.
3.
Save the setup by scanning the following bar code
twice
.
(This bar code also appears on the last page of this booklet.)
*E*
*E*
*F*
START
*$+$-*
NOTE
To quit Auto-Learn mode without saving the setup,
scan the E bar code and then the F bar code below,
in order.
