8
Mini PowerWedge
®
Laser/Input Modes
The Mini PowerWedge can operate in any of the following modes:
Normal Mode
In normal mode, the Mini PowerWedge accepts bar code or magnetic
stripe input from all supported types of input devices except serial
devices. This is the default setting for the Mini PowerWedge’s laser/
input modes.
Autoscan Mode
Use this mode for stand-mounted lasers. This mode returns the laser
to the ready-to-read state immediately after each read.
Multiscan Mode
This mode allows you to scan bar codes without pressing and releas-
ing the trigger for each read. In this mode, the laser or CCD remains
in the ready-to-read state for as long as the trigger is held down.
Symbol Blinking Mode
Use this mode for automatic scanning with a Symbol laser mounted
on the Symbol IntelliStand.
Serial Input Mode
In this mode, the Mini PowerWedge accepts input from serial devices
or wands. All other input is disabled.
NOTE
Bar codes for setting laser/input modes are on page
56.
