PSC Falcon 4620, User Manual

Page: 10 / 32

*HWWLQJ6WDUWHG
)DOFRQ
Š
)LJXUH 3RZHUDQG'LPPHU%XWWRQV
1. Turn the power on by pressing the power button, illustrated above.
2. When the start-up sequence is complete, the system is ready for use.
Upon initial boot-up the Falcon 4620 will go through the calibration
sequence. Refer to “Calibrating the Touchscreen” on page
7
for more
information.
3. You can now open and run the desired applications.
3RZHU6XSSO\
Power is supplied by the vehicle to which it is mounted, or an external AC
power supply. PSC provides the following four power accessories:
Refer to
page 25
for more information on power supplies.
7XUQLQJWKH8QLW2II
1. Close all applications.
2. Select
Start > Shut down
.
3. When
It is now safe to turn off your computer
dialog opens, press and hold
the power button for seven (7) seconds or until the screen goes blank.
Dimmer Buttons Power Button
Power Cable with Bare leads 8 foot long (One bare leads power cord is included with the
unit when ordered.)
Power Supply 110/220 VAC Power supply (70w)
DC to DC Power Converter
DC to DC Converter (18VDC - 72 VDC for vehicles > 24
volts.)
DC/DC Delay Timer/Filter DC/DC Delay Timer/Filter
R44-2394.book Page 6 Tuesday, December 23, 2003 10:02 AM