PSC Scanning Imager 8000, On-Screen Programming And Viewing Manual

Page: 77 / 88

R44-2080 B-1
Appendix B
Troubleshooting & Maintenance
Cable Connections
Ensure your reader-to-host interface cable (I/F) and the Reader
power supply cable are correctly and firmly attached.
The Imager 8000 2D Reader requires a preinstalled 9- or 25-pin con-
nector interface (I/F) cable and an AC/DC power adapter approved
by PSC.
To install your reader to your host system, follow these instructions
(refer to Figure B-1):
1. With the host powered down, connect the I/F cable to the
proper port on the host terminal.
2. Connect the power cord to the I/F cable.
3. Connect the AC/DC power adapter at the wall outlet.
4. Turn on the host computer.
If the Reader is simply not functioning, contact your service represen-
tative or contact PSC. See
Contacting PSC in this section.
CAUTION
To avoid possible damage, consult your host terminal/
PC operator’s manual for instructions on powering down
the host system before connecting peripheral devices.