Configuration on the Web Console
92
Commissioning
Commissioning with configured MAC address
You will find the MAC address on the label attached to the back of the SIP
system telephone. If you configure the SIP system telephone with it’s MAC
address, the device is ready for use after starting up.
Commissioning without entering the MAC address
To configure the SIP system telephone without entering a MAC address, you
must set the DHCP mode to
Dynamic and static address assignment
, either
for all devices (
All
setting) or for all SIP system telephones (
with configured
MAC only and all SIP system devices
setting). You can change the DHCP
mode in the
Configurator > Network > DHCP
menu.
In the
VoIP phones
dialogue, a part of the MAC address is already set. You do
not need to remove the preset value if you configure the SIP system
telephone without MAC address.
When configuring the SIP system telephone without MAC address, it is
necessary to perform a one-time login procedure after the device is started.
1.
Enter the call number of the SIP system telephone. Confirm the input
with
(Forum IPhone 5010/5020/5025/5030) or with
(Forum IPhone 5040).
2.
Enter the user PIN. The default PIN for a user on the Forum 500 /
Forum 5000 communications system is “0000”. Confirm the input
with
(Forum IPhone 5010/5020/5025/5030) or with
(Forum IPhone 5040).
The SIP system telephone restarts to apply the configured call number.
Internet Address
When operating the DHCP server in the
Static address assignment
mode,
you need to enter an IP address when configuring a SIP system telephone.
This IP address is then automatically entered into the list of the DHCP entries
that is managed by the communications system. This configuration is
recommended to prevent conflicts when putting the SIP system telephones
into service.
If you operate the DHCP server in the
Dynamic and static address
assignment
mode, entering an IP address is optional. In this case, the terminal
will automatically be assigned an IP address by the DHCP server when
