Special Calls/Conversations
160
Telephoning
Entrance Intercom Calls
Calling the entrance intercom
The code procedure for calling the door intercom is determined by the system
administrator. Possible codes are:
* 1 0 2
to
* 1 0 9
Contact your system administrator regarding the valid code procedure.
Alternative: You can also call the door intercom by selecting the
Connections > Door call
entry from the
Main menu
or by pressing a
programmed
Door call
feature key (see also page 106).
Signal when the handset Is on hook
H
Lift the handset.
●
If your system is connected to an entrance intercom, you can speak to your
visitor.
●
Otherwise you will hear a special door tone when you lift the handset.
Signal during a call
G
If the doorbell signal is triggered during a call, you hear a call waiting tone.
Proceed as described in the chapter
H * 1 0 2
If an analogue entrance intercom (e. g. of the
“doorphone” type) or a SIP entrance intercom is
connected to your system, you can use this
procedure to speak with a visitor.
In an enquiry call:
G
/
/
/
* 1 0 2
: R key on the Forum IPhone 5010 (if the
enquiry function has not been programmed on
another function key)
: R key on the Forum IPhone 5020
: R key on the Forum IPhone 5030/5040
(programmed function key)