Configuration
Tsunami MP.11 5012/5054-SUI Installation and Management
Network Parameters
68
If your network does not support Spanning Tree, be careful to avoid creating network loops between radios. For example,
creating a WDS link between two units connected to the same Ethernet network creates a network loop (if spanning tree
is disabled).
The Spanning Tree configuration options are advanced settings. Proxim recommends that you leave these parameters at
their default values unless you are familiar with the Spanning Tree protocol.
Click the
Spanning Tree
tab to change Spanning Tree values.
Edit/Disable Entries in the Priority and Path Cost Table
1. Click
Edit Table Entries
to make changes
2. Enter your changes and click
OK
.
IP Routes (Routing Mode only)
NOTE:
The unit must be in Routing mode to configure IP Routes.
Click
Configure
>
Network
>
IP Routes
to configure.
