Prowinch PWTR Series, User'S Manual And Safety Warnings, Page: 14 / 36

14
Installation
a) For models PWTR9500 and PWTR13000 Control box is Preinstalled from factory.
b) For models PWTR15000 and PWTR17000 Over de Winch Motor.
4. INSTALLATION
4.1 INSTALLATING THE CONTROL BOX
(recommended before installing winch to vehicle).
The control box can be mounted in various ways depending on the application.
The control box can be mounted in two positions:
Fig. 2
1) Install the two black motor mount brackets on the bottom of the control box by removing the four nuts on the bottom of the box,
then placing the brackets over the bolts and then secure brackets by re-installing the nut.
Note: The end of the brackets point outward. (Fig. 2) Be careful when installing brackets in order not to push the
bolts up into the control box. To help prevent this, install brackets with the control box on its side instead of laying it flat.
2) Install the control box by lining it up with the two holes on the motor side upright, then cecure with the included hardware.
Dimensions are in mm
I
t´s very important that the winch be mounted on a flat surface so that the three
sections (motor, rope drum and gear housing) are properly aligned.