ProteOn XPR36, User Manual

Page: 212 / 288

ProteOn XPR36 System | A ProteOn XPR36 Instrument and Peripherals
194
respectively. These buttons are not active (the LEDs are off) when
an experiment is in progress
• Use the Stop button to stop the pumps in the following
circumstances: (1) to replace the current buffer bottle, and (2) to
change the buffer source bottle (switch the valve) from the buffer A
bottle to the buffer B bottle. This button is not active when an
experiment is in progress
Note: You can also control the buffer bottle valve selection
through ProteOn Manager software.
See Selecting Buffer Bottles on page 28 for more information.
Serial Numbers
The buffer compartment and rear panel display serial number labels.
Caution: When pressing Stop, allow
approximately 5 seconds for valve switching
before pressing the buffer control button on the
instrument or the Valve/Flush button in the
software interface.