21
S-PARK
- rev.1.1_06_2020
7. MAINTENANCE
ATTENTION! - Maintenance must be performed by qualified
personnel in compliance with outstanding safety regulations of
current legislation.
Maintenance service has to be regular every 6 months.
Before proceeding double check the following conditions:
• Switch the power OFF.
• Check the good condition of every component.
• Check all screws are properly tight (especially the equalizer
lever and boom bracket).
• Check spring turns are regularly distanced without deformation.
• Check the correct position of limit switches inside the cabinet.
• Release and check the correct boom balancing, and possible
friction during manual opening and closing.
• If boom is not properly balanced as per balancing instructions,
put the boom to vertical position and adjust the spring accordingly.
Then double check the balancing again.
• Lock the barrier and proceed to general test.
7.1
Manual operation check
• Check the manual release system: put the boom in closing
position, unlock and test manual operation.
Manual operation has to be eazy and effortless.
• Boom has to open without friction nor interrumption.
• Handle rotation has to be effortless without frictions.
Record every single intervention in the space provided, chapter
8.3 Maintenance
, service and repairings must be documented and
the owner must keep the related documents.
8. END USER’S TIPS
Dear user, it is highly recommended to read the following pages
because they may contain essential information for the safety of
people and things, and in compliance with applicable laws.
Store these pages in a safe place for future reference.
8.1 Warnings
Keep the system away from children under 8.
Children and People with reduced physical, sensory, mental
or limited experience and / or knowledge can use automation
only if they are provided with supervision or specific
instructions regarding the safe use of the same.
The use of this product for purposes other than those
described above and installation executed in a manner other
than as instructed in this technical manual are prohibited.
Do not, for any reason, access the internal parts of the
automation: they are dangerous and there are no components
that can be repaired or replaced by unqualified personnel.
Use remote controls or other control devices only when the automation
is visible and there are no dangerous situations.
Do not allow children to play near the automation area.
8.2
Boom manual release
To unlock the automation, use the lock located on the right side of
the cabinet.
Turn the supplied key anticlockwise by 180 ° to release the handle.
Turn the handle fully clockwise to unlock the automation.
These operations must be carried out in the event of power cut or
operating anomalies.
ATTENTION: HOLD THE BOOM WITH YOUR HAND, IT COULD
ACCIDENTALLY MOVE.
Picture 29: Locked
Picture 30: Unlocked
1)
TURN THE KEY COUNTERCLOCKWISE
2)
TURN THE HANDLE
CLOCKWISE
