
INSTALLATION INSTRUCTIONS
85mm EVO SPEEDOMETER
W/WARNING & PEAK
WHITE/AMBER /BLUE / GREEN LED DISPLAY
□
1
E
A
BEFORE YOU START
1.
Read instructions completely before installation.
NOTE: It may be necessary to reprogram your radio,
2.
Install speedometer only when engine is cool and
clock, etc. after reconnecting the battery.
ignition is off.
6. Make sure mounting location does not impair visibility of
3.
Make sure all necessary tools, materials, and
interfere with driving. Also check behind the mounting
parts are on hand.
location for any wiring or components before drilling.
4.
Refer to your vehicle’s service manual for the location 7. When connecting electrical wire, install crimp terminals
of speedometer sensor port, vacuum system, and/or
and make wire splices as needed. ALWAYS insulate wire
charging system.
splices with electrical tape to prevent shorting.
5.
Disconnect negative (-) battery cable before installing 8. Follow all necessary safety procedures for protection.
speedometer.
A
□
2
E
A
SPEED RANGE SWITCH SELECTION
1.
Use the switches
< 1.2.3.4.5.6.7.8.9.0>
to adjust the
SPEED
into an approximate range.
2.
Switch toward <0.9.8.7.6.5.4.3.2.1.> to narrow the range.
Switch toward <1.2.3.4.5.6.7.8.9.0.> to widen the range.
A
□
3
E
A
MOUNTING
You can mount your speedometer on or under the dashboard or on the center console according to your personal choice.
Determine best position for good visibility before drilling screw holes.
A
□
4
E
A
SPEEDOMETER CONNECTION
1.
Connect power wire (RED) to +12V battery wire.
5. Secure lead wires along their route to prevent damage
2.
Connect power wire (WHITE) to a sw12V
from sharp edges, moving parts or hot engine
circuit at fuse box, or splice into any vehicle harness
components.
wire which is energized ONLY when ignition key is
6. Turn on ignition. DO NOT START ENGINE speedometer
ON (RUN) position.
Lcd display should be to minimum or “0” when ignition
3.
Connect power wire(BLACK) to ground, negative (-)
is turned on.
battery terminal or a good chassis ground.
4.
Connect power wire (ORANGE) to panel lights circuit
at fuse box, or splice into any vehicle harness wire
connected to the panel lights circuit.
.
www.prosportgauges.com email: [email protected]