3.10
Moisture in Display
3.10.1
Water seen inside display after washing the mounting area
•
Radio is not designed to withstand pressurized streams of water. When rinsing the radio or around the radio, a
very low pressure spray is recommended.
•
Monitor the display for possible evaporation without harm to the radio.
•
Monitor the radio for strange or erratic behavior. If the issue persists, internal damage has occurred – seek to
repair or replace.
3.10.2
Slight fog after operation
– normal in colder weather. Allow radio to run for 1-2 hours; this will burn off
moisture.
3.10.3
Heavy condensation
•
The condensation may evaporate without harm to the radio. See “slight fog after operation.”
•
Monitor the radio for strange or erratic behavior. If the issue persists, internal damage has occurred – seek to
repair or replace.
3.11 Erratic Controls
3.11.1
Radio does not have remotes attached
Reset the radio in “4”
Check for stuck buttons. If buttons are stuck, initiate a warranty claim if under warranty.
Check for moisture or condensation in the screen. If moisture is in the screen, see “3.10.3”
Replace radio if under warranty
3.11.2
Radio has remotes attached
Disconnect all remotes from the radio. Test radio function again
. If erratic controls persist, see “3.11.1”
If erratic controls stop, plug in one remote directly into the back of the radio
without extension
If 1 remote works, repeat process for each remotes respectively. If erratic controls start when the remote is
plugged in, file warranty for the defective remote if you are under warranty.
If radio AND remote(s) work, try remote(s)
with
extension
If problem appears when extension is used, file warranty for the extension if you are under warranty.
3.12
Bluetooth Won’t Work
3.12.1
Bluetooth Won’t Pair
Make sure your Bluetooth device is turned on and set to scan
Make sure the INFPRV250 is on BT MUSIC. Hold down the 3 button until PAIRING appears
Turn all other Bluetooth devices off so the radio doesn’t get confused with what Bluetooth device to pair to.
Turn the pairing on the Bluetooth device first before pairing is turned on the radio.
Reboot your Bluetooth device.
Turn off the Wi-Fi on your Bluetooth device.
Reset your radio using the reset procedure in 4.
Try with another Bluetooth device.
Initiate warranty claim if nothing above works and you are within warranty.
Note
: Bluetooth will only work with Bluetooth streaming in but not out. This means that phones can stream
Bluetooth music in, but Bluetooth headphones that stream out will not work.
3.12.2
Bluetooth Code needed
Bluetooth code for the INFPRV-250 is 1234.
