Rack Mounting
(1) Access the Web Configurator via UPLINK port or LINE ports.
STEP 1: Enter the default IP address
192.168.1.1
as URL in your web
browser.
STEP 2: Please enter the default username
root
and the default
password
2wsx#EDC
.
STEP 3: Click Login button.
(2) Change the default password.
Go to
User
setting and reset your new password and then click
Apply
button.
NOTE:
The default password should be changed after configuration. Please avoid using easy to
guess passwords (e.g., root, 1234...).
Setup
STEP 1:
Align two brackets with the holes on the sides of the Switch and
fasten the mounting kits by using screws.
NOTE:
The type of screw is flat head M3 x 5mm.
STEP 2:
After attaching two brackets, line up the rack-mounting positions
of the holes in the brackets with the appropriate holes on the rack
and then fasten the Switch on the rack by using screws.
NOTE:
The rack-mounting screws are not included in the package.
NOTE
Please scan below QR Code to download online resources.
Download Link: https://www.proscend.com/en/product/708E.html
708EP-AC
ATTENTION: Safety Warning
Disconnect all power from devices before attempting installation.
This device is intended for installation only in restricted access locations as defined where both
these conditions apply:
・
Access is through the use of a lock or tool and key, or other means of security, and is controlled
by the authority responsible for the location.
・
Access can only be gained by service persons or by users who have been instructed about the
reasons for the restrictions applied to the location and about any precautions that shall be
taken.
All electric installations must be carried out in accordance with local and national regulations.
Do not work on the system, connect or disconnect cables during periods of lightning activity.
The equipment must be connected to earth.
Shield of RJ45 cables has to be connected to the same earth potential as the equipment.
Please remove the ground connection lastly if you need to remove the device after installation.
If the LINE interface is used for the connection between two buildings, all necessary protective
measures must be ensured externally.
This equipment relies on the building’s installation for short-circuit (overcurrent) protection. Ensure
that a fuse or circuit breaker no larger than 3.5 is used.
- 2 -
Proscend Communications Inc. All rights reserved.
www.proscend.com
P/N:604040000076