background image

Made in China

V1.0

15

INSTRUCTION BOOKLET

WARNING: Never leave product charging unattended for extended periods of

time. Always disconnect the battery from charger immediately after the battery

is fully charged. Please refer to enclosed safety instructions.

PACKAGE CONTAINS:

Colors and styles may vary slightly .

Instruction 

Manual

Spare Parts

Battery

Foot Pad

SNAP 2.0™ 

PROPEL

USB Charger 

2.4G Wireless

 Controller

ON BOARD

HD VIDEO

ON BOARD

HD CAMERA

1280 x 720 pixel 
30 frames per second

Phone Holder

CHOKING HAZARD - Small parts. 
Not suitable for children under 3 years.

WARNING!

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

s2EORIENTORRELOCATETHERECEIVINGANTENNA

s)NCREASETHESEPARATIONBETWEENTHEEQUIPMENTANDRECEIVER

s#ONNECTTHEEQUIPMENTINTOANOUTLETONACIRCUITDIFFERENTFROMTHATTOWHICHTHERECEIVERISCONNECTED

s#ONSULTTHEDEALEROREXPERIENCEDRADIO46TECHNICIANFORHELP

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : 
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired  
      operation.

4HISEQUIPMENTCOMPLIESWITH&##)#RADIATIONEXPOSURELIMITSSETFORTHFORANUNCONTROLLEDENVIRONMENT

This equipment should be installed and operated with minimum distance 20cm between the radiator and 
your body.

#ETÏQUIPEMENTESTCONFORMEAUXLIMITESDgEXPOSITIONAUXRADIATIONS&##)#ÏTABLIESPOURUN

environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 
cm entre le radiateur et votre corps.

CAN ICES-3(B)/NMB-3(B)

This product meets the applicable Innovation, Science and Economic Development Canada 
technical specifications. 

Compact Folding Drone with HD Camera

This product is manufactured by Amax Group
12645 Memorial Drive Suite F1 #388 Houston, TX 77024
Propel™ and Propel RC™ are the licensed trademarks of Rooftop Group LTD Singapore.
2008 All rights reserved. Visit us at www.propelrc.com

 

SNAP 2.0

TM

INDUSTRY CANADA NOTICE: CANADA ONLY.

4HISDEVICECONTAINSLICENCEEXEMPTTRANSMITTERS RECEIVERS THATCOMPLYWITH)NNOVATION3CIENCEAND%CONOMIC$EVELOPMENT

Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

,ÏMETTEURRÏCEPTEUREXEMPTDELICENCECONTENUDANSLEPRÏSENTAPPAREILESTCONFORMEAUX#.2D)NNOVATION3CIENCESET

Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions 
suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le 
fonctionnement.

Conforms to safety requirements of FCC, RSS247, RSS210.

Summary of Contents for SNAP 2.0









Reviews: