PRONOVA FOS/TAC 2000, User Manual

Page: 7 / 31

FOS/TAC 2000 GENERAL SAFETY INFORMATION
812-04.2015-EN FOS/TAC 2000 User Manual 7
1 General safety information
The following safety information must always be observed during operation as well as during any maintenance and repair work on
this device. Non-compliance with safety measures or any other information or warnings contained in this user manual constitutes a
violation of safety standards underlying the design, manufacture and proper use of the device.
Non-compliance with such information can cause hazards for users and/or damage to the device! The manufacturer does not
accept any liability for losses or damage caused by non-compliance with such safety measures on the part of the customer.
In order to avoid any additional hazards, unauthorized modification of the device is not permitted. In the event that repair work is
necessary, the device should be returned to our service centre after prior notification.
Users are not permitted to open the device. Certain activities – such as replacing hardware components or internal settings – may
only be carried out by qualified personnel.
Devices which are suspected to be at fault or defective must be switched off and protected against unauthorized access until the
necessary repair/service work has been performed by qualified personnel.
When working in explosive or flammable environments, do not operate the device without additional protection measures!
Possibility of aggressive media. Please refer to the safety data sheet for the titration solution contained in the appendix to
this document!
When working with the device – for example, during measuring, calibration or maintenance work – always wear protective
glasses and suitable protective clothing.
When connecting the device, make sure that the correct mains voltage is available, and proceed in accordance with the information
in the section titled "Requirements for the place of installation, power supply".
Before performing any fault-finding or repair work, or before replacing any parts, disconnect the device from any voltage
sources! In the event that work must be performed on the live, opened device, this may only be carried out by an informed
skilled technician who must be familiar with the related risks and hazards!