________________________________________________________________________________
10
–
Lift trolley Lift&Drive
70IE / 90IE / 90JE
For lift trolleys with a power pack equipped with a voltage indicator a flashing bar on the voltage
indicator means that the batteries need charging. If the lift trolley is left unused for 10 minutes
sleep mode is activated and the voltage indicator turns black. The lift trolley can be restarted by
pressing any button on the remote control. When the lift trolley is restarted from sleep mode
after charging it takes two minutes before the voltage indicator shows if the batteries are fully
charged.
5.2
Every year, or when needed
5.2.1
Cleaning
Clean the lift trolley using detergent suitable for painted surfaces, aluminium and stainless steel.
Follow the instructions on the detergent. Wipe the lift trolley dry after cleaning. Do not use hose
or high-pressure jet as this may damage the electronics and the paint.
5.2.2
Electrical connections
Check all connections and repair any damage or wear. If needed, replace with new parts.
5.2.3
Wear of machine parts
Check the parts of the machine in order to identify any cracking or wear.
5.2.4
Nuts and bolts
Make sure all nuts and bolts are tightened.
5.2.5
Lift column
Lift the column from the cross-member.
Clean the brush stripes and wipe the column clean.
Remove the four corner screws at the top of the column. (Not the three in the middle)
Pull out, wipe and lubricate the lift screw with new ball bearing grease.
Put the lift screw back and tighten the screws.
Check the coupling, by making sure the sleeve and the hub located inside the column and inside
the cross-member are intact and in working order.
Put the lift column back and perform load test, see section
Assembly
.
5.2.6
Wheels
Make sure all wheels run smoothly.
Lubricate the bearings.
Check that the tire rubber is intact.
5.2.7
Brakes
Check that the breaks work.
