LIZARD
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
12
3.4. Starting
Plug the power cord into the power source and turn on the power by setting the
power switch to the
position ‘I’. The initial screen with the version number of the
current firmware will show on the display, and the carriage will automatically check
for an oscillator connected to the oscillation socket. If the oscillator is connected,
confirmation message will show. After the initialization of the
control system, the main menu from Fig. 6 will show on the display.
Fig. 6.
Example of the main menu
Press and hold the knob F1 for about 3 seconds to enter into the configuration
menu to set welding parameters.
3.5. Programming
The LIZARD welding carriage allows defining up to 40 welding programs. After
entering into the configuration menu, proceed as described in Fig. 7 to move among
the parameters from Tab. 1.
Fig. 7.
Configuration menu
Current operating state
Program
number
Unit of speed
Value of speed
Name of parameter. Rotate the knob F1 to change
among parameters listed in Tab. 1.
Value of parameter. Rotate the knob
F2 to change the value by the higher
step indicated in Tab. 1. Press and
rotate the knob F2 to change the
value by the lower step.
Unit of parameter. Can be changed from the
setting.
