HYDROGEN
INHALATION MACHINE
INSTRUCTION MANUAL
SETUP INFORMATION
ASSEMBLY AND FIRST USE
1. Unpack the machine and all accessories from the shipping box.
2. Check for any damage.
3. Place the machine on a level surface.
4. Locate the packet of electrolyte mix in the gas purifier cup on
the far right of the machine. Make sure to read the electrolyte
warnings on page 3. Carefully remove the cap by unscrewing the
cup while holding the cap, and remove the packet.
5. IMPORTANT
: Read the safety warnings before continuing.
6. Remove the fill cap on the top of the machine by unscrewing.
7. Place a towel over the machine to protect it from any accidental
spills.
8. Carefully open the packet of electrolyte mix.
9. Using the supplied funnel, slowly and carefully pour the entire
contents of the packet of electrolyte mix into the machine
without spilling.
10. Plug in the machine before proceeding. IMPORTANT: The LEDs
will not function without power.
11. Notice that the “Refill” LED (Red) is illuminated.
12. Measure about 28 oz. / 800ml of water.
13. Slowly pour the water into the machine.
14. Keep pouring slowly until the Red LED goes out.
15. Continue to pour until the Green LED illuminates. This indicates
that the Hydrogen Generator is full.
Do not overfill the
machine.
16. Replace the fill cap and tighten hand-tight.
17. Fill the two plastic Gas Purifier cups with Distilled Water. Only
use Distilled Water for the Gas Purifier cups. Fill cup to within 1/2”
of the top ring
(see image)
. Screw cup back onto the top and
insert back into the holder. Repeat with the second Gas Purifier
cup. When re-attaching the cups, make sure that the caps are not
cross-threaded, which can cause leaks. Make sure that the tubing
is not kinked or twisted.
18. Pressure test your machine.
1. Attach the Water Infusion accessory to the Gas Output
fitting. Attaching the Water Infusion accessory will cause
a slight pressure to build up and will verify that no leaks
exist.
2. Place the Water Infusion accessory into a glass of
drinking water.
3. Press the “1 Min” button. Within a few seconds, gas
bubbles should begin to form in the Molecular Hydrogen
generator and become visible in the clear tube. The gas
will also begin to bubble through both of the Gas Purifier
cups. If bubbles
do not
appear in both Gas Purifier cups,
ensure that the fill cap is properly seated and tightened.
If bubbles still do not appear, make sure that the lids are
seated correctly and not cross-threaded. Gas will begin
to bubble through the Water Infusion Stone into the
glass of drinking water.
4. Press the “Off” button. Disconnect the Water Infusion