Lock release lever (back left)
Determine which holes to use on rack
I
nStall
tHe
SlIdIng
raIlS
and
Place
devIce
In
rack
Follow these steps to install the sliding rails in the rack system, then place the Vess A3340 onto the rails and
secure the device to the rack.
1. Determine what height to place the 2U enclosure in the rack, then place the right and left rack rails at the
same height on in the right and left rack position. Choose the mounting holes accordingly for your rack
system. Note that three holes are required on each front post, the uppermost of the three to be used
for the flange nuts to anchor the enclosure to the rack posts. Adjust the length of the mounting rails as
needed.
Notice that each end of the sliding rails have a lever to
operate the lock mechanism that grips the rack post.
13
Hardware Setup
Vess A3340 Product Manual
